Fire control tower
Encyclopedia
A fire control tower is a structure located near the U.S. coast that was used to detect and locate enemy vessels offshore, direct fire upon them from coastal batteries, or adjust the aim of guns by spotting shell splashes. These towers were part of the U.S. Coast Artillery fire control system
, and were used between about 1900 and the end of WW2.
A fire control tower usually contained several fire control stations, known variously as observation posts (OPs), base end station
s, or spotting stations from which observers searched for enemy ships, fed data on target location to a plotting room
, or spotted the fall of fire from their battery, so the aim of the guns could be adjusted. For example, the fire control tower at Site 131-1A (diagrammed at right) contained one OP, two base end stations, and two spotting stations. A shorthand notation was used to identify the stations.
For instance, the top story of this tower was planned to contain base end station #3 and spotting station #3 for Battery #15. The overall plan document for the harbor defenses contained a list that linked the tactical numbers of all batteries to their names. That document also contained an organization chart that identified all the Command (C) and Group (G) codes, like "G3."
These towers were arrayed in networks along the coast on either side of the artillery batteries they supported. The number and height of the towers was determined by the range of the guns involved. Many fire control towers were also part of a harbor's antiaircraft warning system. Spotters occupied cramped "crow's nests" on the top floors of the towers that enabled them to lift a trapdoor in the tower's roof and scan the sky for approaching aircraft.
When an enemy surface craft was detected, bearings to it were measured from a pair of towers, using instruments like azimuth scopes or depression position finders
(see photo at left). Since the distances along the line between the towers (called a baseline) had already been precisely measured by surveyors, the length of this baseline, plus the two bearing angles from two stations at the ends of the line (also called base end stations
) to the target, could be used to plot the position of the target by a mathematical process called triangulation
.
A fire control tower was usually 5 to 10 stories tall, depending on the height of the site at which it was built and the area it had to cover. Often made of poured concrete, its lower floors were usually unoccupied and were capped by occupied observation levels. Staircases ran up to the lowest observation level, and wooden ladders were then used to climb to higher levels (see elevation drawing above at right). But some fire control structures built atop coastal hills or bluffs only needed to be one- or two-story buildings, and were built of wood or brick (see examples pictured in the Gallery below). Sometimes these buildings were camouflaged as private homes, and were referred to as fire control "cottages."
A plan drawing of each floor of our sample tower is shown at left. The center of octagonal concrete mounting pad on the 8th Floor (which was meant to support a depression position finder) was usually the surveyed point at the end of the baseline (and thus the precise location of the base end station). A survey marker
embedded in the tower's roof directly above this pad defined this point. Other observing instruments on lower floors of the tower were usually lined up directly beneath the 8th Floor mounting pad and the rooftop marker, so they shared the same latitude and longitude. The pipe stands shown on Floors 6 and 7 of the Nahant Site 131-1A tower probably held azimuth scopes, which were less complex telescopes that determined bearings to a target but not its range from the tower.
This tower had electric lights, phones, and radio communications, and a time interval bell that was used for coordinating fire control information. Some fire control towers were also the mounting points for coast surveillance or fire control radar antennas. Although our sample tower has a simple, square appearance, some versions of these towers in New England had round or partly octagonal plans.
For a WW2-era example, take Battery Murphy, the two 16-inch guns in Nahant, MA. The map at left shows the 10 fire control stations that made up Battery Murphy's fire control network, which was spread out over about 40 miles of coastline running from Station 1 (Fourth Cliff
) in the south to Station 10 (Castle Hill) in the north. Half of these stations were located in tall towers, and half in low-rise cottages.
The length of the baselines running between each pair of stations was known very precisely. For example, Station #1 and Station #2 were 12,249.63 yards (about 6.96 miles) apart. These distances were plugged into the triangulation equations for the pair of stations involved in sighting on a particular target in order to compute its position. As the target ship moved along the coast, different pairs of fire control stations (and therefore different baselines) would come into play. Very precise measurements were also taken of the distance between the directing point
of each battery (often the pintle center of its Gun #1) and each fore control station's observing point. These distance could also be used for target location, if one of the observations was taken from the battery itself and another from the distant station.
Coast Artillery fire control system
In the U.S. Coast Artillery, the term fire control system was used to refer to the personnel, facilities, technology and procedures that were used to observe designated targets, estimate their positions, calculate firing data for guns directed to hit those targets, and assess the effectiveness of...
, and were used between about 1900 and the end of WW2.
A Typical Fire Control Tower
The photo at left shows two typical fire control towers on Swallow Cave Rd. in Nahant, MA, known during WW2 as Site 131. The tower at Site 131-1A (on the right in the photo) is the example described here. Built in 1943-44, these twin towers watched over the northern approaches to Boston Harbor and directed the guns of several different Coast Artillery batteries. Towers similar to these can be found today in all coastal New England states.A fire control tower usually contained several fire control stations, known variously as observation posts (OPs), base end station
Base end station
Base end stations were used by the U.S Coast Artillery as part of fire control systems for locating the positions of attacking ships and controlling the firing of seacoast guns, mortars, or mines to defend against them....
s, or spotting stations from which observers searched for enemy ships, fed data on target location to a plotting room
Plotting room
A plotting room was used by the U.S. Coast Artillery to house a team of soldiers who were engaged in controlling fire for the guns of a Coast Artillery battery...
, or spotted the fall of fire from their battery, so the aim of the guns could be adjusted. For example, the fire control tower at Site 131-1A (diagrammed at right) contained one OP, two base end stations, and two spotting stations. A shorthand notation was used to identify the stations.
For instance, the top story of this tower was planned to contain base end station #3 and spotting station #3 for Battery #15. The overall plan document for the harbor defenses contained a list that linked the tactical numbers of all batteries to their names. That document also contained an organization chart that identified all the Command (C) and Group (G) codes, like "G3."
These towers were arrayed in networks along the coast on either side of the artillery batteries they supported. The number and height of the towers was determined by the range of the guns involved. Many fire control towers were also part of a harbor's antiaircraft warning system. Spotters occupied cramped "crow's nests" on the top floors of the towers that enabled them to lift a trapdoor in the tower's roof and scan the sky for approaching aircraft.
When an enemy surface craft was detected, bearings to it were measured from a pair of towers, using instruments like azimuth scopes or depression position finders
Depression position finder
A depression position finder is an observation instrument that was used in the fire control system of the U.S. Coast Artillery to locate targets in range and/or azimuth as part of the process of directing the fire of a battery of coast defense guns or mortars...
(see photo at left). Since the distances along the line between the towers (called a baseline) had already been precisely measured by surveyors, the length of this baseline, plus the two bearing angles from two stations at the ends of the line (also called base end stations
Base end station
Base end stations were used by the U.S Coast Artillery as part of fire control systems for locating the positions of attacking ships and controlling the firing of seacoast guns, mortars, or mines to defend against them....
) to the target, could be used to plot the position of the target by a mathematical process called triangulation
Triangulation
In trigonometry and geometry, triangulation is the process of determining the location of a point by measuring angles to it from known points at either end of a fixed baseline, rather than measuring distances to the point directly...
.
A fire control tower was usually 5 to 10 stories tall, depending on the height of the site at which it was built and the area it had to cover. Often made of poured concrete, its lower floors were usually unoccupied and were capped by occupied observation levels. Staircases ran up to the lowest observation level, and wooden ladders were then used to climb to higher levels (see elevation drawing above at right). But some fire control structures built atop coastal hills or bluffs only needed to be one- or two-story buildings, and were built of wood or brick (see examples pictured in the Gallery below). Sometimes these buildings were camouflaged as private homes, and were referred to as fire control "cottages."
A plan drawing of each floor of our sample tower is shown at left. The center of octagonal concrete mounting pad on the 8th Floor (which was meant to support a depression position finder) was usually the surveyed point at the end of the baseline (and thus the precise location of the base end station). A survey marker
Survey marker
Survey markers, also called survey marks, and sometimes geodetic marks, are objects placed to mark key survey points on the Earth's surface. They are used in geodetic and land surveying. Informally, such marks are referred to as benchmarks, although strictly speaking the term "benchmark" is...
embedded in the tower's roof directly above this pad defined this point. Other observing instruments on lower floors of the tower were usually lined up directly beneath the 8th Floor mounting pad and the rooftop marker, so they shared the same latitude and longitude. The pipe stands shown on Floors 6 and 7 of the Nahant Site 131-1A tower probably held azimuth scopes, which were less complex telescopes that determined bearings to a target but not its range from the tower.
This tower had electric lights, phones, and radio communications, and a time interval bell that was used for coordinating fire control information. Some fire control towers were also the mounting points for coast surveillance or fire control radar antennas. Although our sample tower has a simple, square appearance, some versions of these towers in New England had round or partly octagonal plans.
A Network of Fire Control Structures
Each major battery of Coast Artillery guns was supported by a network of fire control structures (towers, cottages, or buildings) which were spread out along the nearby coast. Guns of longer range had larger numbers of fire control stations in their networks. Depending on where the target ship was located and upon other tactical conditions, one or more of these stations would be selected to control the fire from a given battery on that target.For a WW2-era example, take Battery Murphy, the two 16-inch guns in Nahant, MA. The map at left shows the 10 fire control stations that made up Battery Murphy's fire control network, which was spread out over about 40 miles of coastline running from Station 1 (Fourth Cliff
Fourth Cliff Military Reservation
Fourth Cliff Military Reservation was a coastal defense site located in Scituate, Massachusetts.-History:The Fourth Cliff Military Reservation was built on private land...
) in the south to Station 10 (Castle Hill) in the north. Half of these stations were located in tall towers, and half in low-rise cottages.
The length of the baselines running between each pair of stations was known very precisely. For example, Station #1 and Station #2 were 12,249.63 yards (about 6.96 miles) apart. These distances were plugged into the triangulation equations for the pair of stations involved in sighting on a particular target in order to compute its position. As the target ship moved along the coast, different pairs of fire control stations (and therefore different baselines) would come into play. Very precise measurements were also taken of the distance between the directing point
Directing point
The directing point was a term used in the U.S. Coast Artillery to identify a precisely surveyed point that was used as the point of reference for preparing the firing data used to aim the guns of a given Coast Artillery battery....
of each battery (often the pintle center of its Gun #1) and each fore control station's observing point. These distance could also be used for target location, if one of the observations was taken from the battery itself and another from the distant station.
Gallery of Additional Images
See also
- Fire lookout towerFire lookout towerA fire lookout tower, fire tower or lookout tower, provides housing and protection for a person known as a "fire lookout" whose duty it is to search for wildfires in the wilderness...
, used to spot wild fires - base end stationBase end stationBase end stations were used by the U.S Coast Artillery as part of fire control systems for locating the positions of attacking ships and controlling the firing of seacoast guns, mortars, or mines to defend against them....
- Coast Artillery fire control systemCoast Artillery fire control systemIn the U.S. Coast Artillery, the term fire control system was used to refer to the personnel, facilities, technology and procedures that were used to observe designated targets, estimate their positions, calculate firing data for guns directed to hit those targets, and assess the effectiveness of...
- Flak towerFlak towerFlak towers were 8 complexes of large, above-ground, anti-aircraft gun blockhouse towers constructed in the cities of Berlin , Hamburg , and Vienna from 1940 onwards....
, similar large concrete towers built during WWII for anti-aircraft defense.