A lock-in amplifier is a type of amplifier

Amplifier

Generally, an amplifier or simply amp, is a device for increasing the power of a signal.In popular use, the term usually describes an electronic amplifier, in which the input "signal" is usually a voltage or a current. In audio applications, amplifiers drive the loudspeakers used in PA systems to...

 that can extract a signal with a known carrier wave

Carrier wave

In telecommunications, a carrier wave or carrier is a waveform that is modulated with an input signal for the purpose of conveying information. This carrier wave is usually a much higher frequency than the input signal...

 from an extremely noisy environment (the signal-to-noise ratio

Signal-to-noise ratio

Signal-to-noise ratio is a measure used in science and engineering that compares the level of a desired signal to the level of background noise. It is defined as the ratio of signal power to the noise power. A ratio higher than 1:1 indicates more signal than noise...

 can be -60 dB or even less). It is essentially a homodyne

Homodyne detection

Homodyne detection is a method of detecting frequency-modulated radiation by non-linear mixing with radiation of a reference frequency, the same principle as for heterodyne detection....

 with an extremely low pass filter (making it very narrow band). Lock-in amplifiers use mixing, through a frequency mixer

Frequency mixer

In electronics a mixer or frequency mixer is a nonlinear electrical circuit that creates new frequencies from two signals applied to it. In its most common application, two signals at frequencies f1 and f2 are applied to a mixer, and it produces new signals at the sum f1 + f2 and difference f1 -...

, to convert the signal's phase

Phase (waves)

Phase in waves is the fraction of a wave cycle which has elapsed relative to an arbitrary point.-Formula:The phase of an oscillation or wave refers to a sinusoidal function such as the following:...

 and amplitude

Amplitude

Amplitude is the magnitude of change in the oscillating variable with each oscillation within an oscillating system. For example, sound waves in air are oscillations in atmospheric pressure and their amplitudes are proportional to the change in pressure during one oscillation...

 to a DC—actually a time-varying low-frequency—voltage signal.

The device is often used to measure phase shift, even when the signals are large and of high signal-to-noise ratio

Signal-to-noise ratio

Signal-to-noise ratio is a measure used in science and engineering that compares the level of a desired signal to the level of background noise. It is defined as the ratio of signal power to the noise power. A ratio higher than 1:1 indicates more signal than noise...

, and do not need further improvement.

Recovering signals at low signal-to-noise ratios requires a strong, clean reference signal the same frequency as the received signal.