Vertical damp proof barrier
Encyclopedia
The purpose of a Vertical Damp Proof Barrier is to prevent the ingress of damp and water into subterranean structures such as basements, cellars, tunnels and earth shielded buildings. (Also known as Earth sheltered buildings).
Traditionally, this took the form of several coats of bitumous paint or tar
. This, though cheap, has the disadvantage that any movement in the structure or joints is likely to rupture the paint so allowing water to enter.
Modern solutions take the form of a plastic membrane
, often pre-coated with adhesive and a "peel off" paper that is applied to the outside of the structure before it is buried. Usually, a "priming coat" of bitumous paint has to be applied first. It often comes in one metre wide rolls and is installed with a 100 mm overlap. The membrane has a high modulous of elasticity (that is, it stretches a lot, often by a factor of ten before it ruptures)
Precautions have to be taken that sharp objects in the backfill do not pierce it. Sometimes fine sand is used to backfill but more often insulation boards are laid against it before backfilling, particularly in an inhabited room.
As a further precaution against water ingress, it is recommended that land drains
be installed behind the protected wall at its base to prevent the build up of hydrostatic pressure in wet weather.
Traditionally, this took the form of several coats of bitumous paint or tar
Tar
Tar is modified pitch produced primarily from the wood and roots of pine by destructive distillation under pyrolysis. Production and trade in tar was a major contributor in the economies of Northern Europe and Colonial America. Its main use was in preserving wooden vessels against rot. The largest...
. This, though cheap, has the disadvantage that any movement in the structure or joints is likely to rupture the paint so allowing water to enter.
Modern solutions take the form of a plastic membrane
Membrane (selective barrier)
A membrane is a layer of material which serves as a selective barrier between two phases and remains impermeable to specific particles, molecules, or substances when exposed to the action of a driving force...
, often pre-coated with adhesive and a "peel off" paper that is applied to the outside of the structure before it is buried. Usually, a "priming coat" of bitumous paint has to be applied first. It often comes in one metre wide rolls and is installed with a 100 mm overlap. The membrane has a high modulous of elasticity (that is, it stretches a lot, often by a factor of ten before it ruptures)
Precautions have to be taken that sharp objects in the backfill do not pierce it. Sometimes fine sand is used to backfill but more often insulation boards are laid against it before backfilling, particularly in an inhabited room.
As a further precaution against water ingress, it is recommended that land drains
Land drains
The purpose of a land drain is to allow water in wet or swampy ground to rapidly drain away or to relieve hydrostatic pressure. They are subterranean linear structures which are laid to a fall which should be as steep as practicable. They are used in agriculture and in building construction sites....
be installed behind the protected wall at its base to prevent the build up of hydrostatic pressure in wet weather.